Session Chair:
Mike Wiseman,
PTI Tech

Compatibility of Catalytic Debinding Binders with Metal Powders in Metal Injection Molding
Yoshiki Shirai,
Asahi Kasei Corporation

Safer & Greener Catalytic Debinding Technology for MIM and Metal AM
Stefan Joens,
Elnik Systems, LLC

Sintering for Scale & Lessons Learned from Metal Injection Molding
Stefan Joens,
Elnik Systems, LLC

Session Chair:
Ravindra Kumar Malhotra,
Malhotra Engineers

Effect of Vacuum Conditions on the Densification and Chemical Composition of Sinter Based Additively Manufactured Ti-6Al-4V
Giorgio Valsecchi,
TAV Vacuum Furnaces SPA

Using Controlled Atmospheres to Maximize Sintering Production Rates Using Less Energy and Lowering Emissions
Daniel Enoch,
Messer North America

Comparing Various Delube-Assist Systems Used in PM Sintering Furnaces
Harb Nayar, FAPMI,
TAT Technologies LLC

Session Chair:
John Lyons,
AAG Automotive / Burgess-Norton Mtg. Co.

Investigation of Initial Workpiece Adhesion on CVD TiN, TiC and Aluminum Oxide Coatings During Stainless Steel Machining
Larissa Sirtuli
 

On the Fabrication of Carbide-Reinforced Inconel Coatings Through Laser Processing of Metal-Polymer Films
Carlos Matos,
Universidade de Aveiro

Analysis and Design of Multi-Element Alloys in Powder Metallurgy
Ali Akbar Yadollahi Heydarabadi
 

Session Chair:
Vincent Demers
École de Technologie Supérieure

Cold Spray Deposition of Soft Magnetic Powders with In-Situ Thermite Reaction for Oxide Network Formation
Fabrice Bernier,
National Research Council Canada

Magnetic Properties Optimization and Mechanisms Explanations for Cold Sprayed SmCo Permanent Magnets
Jael Giguere,
Ecole Polytechnique

Rethinking Powder Specifications: Utilization of Wide and Off-Size PSD Powders for LPBF Processing of Ti64
Mahdi Habibnejad Korayem,
Colibrium Additive – GE Aerospace

Session Chair:
Tom Pelletiers,
Kymera International

Optimization of the Chemical Composition and Heat Treatment of Ni-Hard Alloys for the Metal Binder Jet Process
Christopher T. Schade, FAPMI,
Hoeganaes Corporation

Influence of Percent Binder Composition and Print Orientation on Green Strength in Binder Jet Additive Manufacturing
Elrik Heaney,
Advanced Powder Products, Inc.

Towards Dimensional and Compositional Accuracy in Binder Jetting: An Investigation of Process Parameter Optimization and Binder Burn Off
Alexandra Darroch,
University of Waterloo 

Session Chair:
Aamir Abid,
Retech Systems LLC

Electrical Conductivity of Additively Manufactured Conductors at Cryogenic Temperatures
Alexander Goodall,
University of Sheffield

Laser Powder Bed Fusion of an Al-TM-RE Alloy
Buket Yilmaz,
McGill University

Comparison of Material Properties of Additively Manufactured C-Alloyed Molybdenum and TZM up to 1,500 °C
Benedikt Distl,
Plansee SE