AM Tungsten Passes Major Fusion-Reactor Test
Researchers from North Carolina State University, Raleigh, North Carolina, Oak Ridge National Laboratory (ORNL), Oak Ridge, Tennessee, and equipment manufacturer JEOL Ltd., Tokyo, Japan, have demonstrated that large, additively manufactured tungsten components can withstand the extreme environment inside a fusion reactor.
Full-size tungsten tiles produced using electron-beam powder bed fusion (PBF-EB) survived 74 direct plasma discharges during three days of testing at the DIII-D National Fusion Facility in San Diego, California. The tiles experienced roughly four minutes of direct plasma exposure during high-power operation and remained intact even when a neighboring conventional tile melted and sprayed liquid metal onto them.
Manufacturing tungsten is particularly challenging because the metal becomes brittle below about 600 °C (1,112 °F). Conventional laser-based additive manufacturing attempts can result in cracking and porosity. The research team instead used an electron beam to melt tungsten powder layer by layer while maintaining the build environment above approximately 1,400 °C (2,552 °F), helping prevent thermal cracking.
JEOL produced the approximately 140-mm-wide, 20-mm-thick tiles in Japan. Project funding and fusion-materials expertise were contributed by ORNL, while NC State completed finishing work before the components were installed in DIII-D for testing.
According to Dr. Florian Laggner, assistant professor and plasma physicist at NC State, testing additively manufactured tungsten in DIII-D provides essential data on its survivability and erosion under fusion-relevant conditions.
The results represent an important advance for metal powder additive manufacturing, demonstrating that large-scale PBF-EB may offer a practical route for producing complex tungsten components for future fusion-energy systems.
7