| Slovenia | ||||
| The Impact of Binders' Composition on Mould Filling and the Debinding Process | ||||
| Stojana Veskovic, Hidria AET d.o.o. & Drago Torkar, Jozef Stefan Institute | ||||
| Japan | ||||
| Microstructure and Mechanical Properties of MIM Parts by Ultrafine Stainless Powders | ||||
| Noriyuki Hakoda, Kei Ameyama, Noriyuki Yasui, Hiroshi Fujiwara, Ritsumeikan University | ||||
| U.S.A. | ||||
| Injection Molding of Micro-Porous 316L Stainless Steel Parts | ||||
| Ozkan Gulsoy, Pavan Suri, Seong Jin Park, Randall M. German, Center for Advanced Vehicular Systems, Mississippi State University | ||||
| Poland & Spain | ||||
| Comparison of Microstructure and Mechanical Properties of High-Speed Steels Reinforced with the WC Carbides, Produced by PM and PIM Methods | ||||
| Grzegorz Matula, Leszek A. Dobrzanski, Silesian University of Technology & Alejandro Várez, Belén Levenfeld, Universidad Carlos III de Madrid | ||||
| Spain | ||||
| Microstructure, Magnetic and Mechanical Properties of Ni-Zn Ferrites Prepared by Powder Injection Moulding | ||||
| Alejandro Várez, Jesus Gutierrez-Löpez, Elena Rodriquez-Senin, Belén Levenfeld, Universidad Carlos III de Madrid, José Y. Pastor, ETSI Caminos & Miguel A. Paris, Hispanoferritas | ||||
| Spain | ||||
| Rheological Behaviour of Alumina Feedstocks for Powder Injection Moulding | ||||
| Belén Levenfeld, Patricia Thomas, Alejandro Várez, Universidad Carlos III de Madrid & Alberto Cervera, Euroortodoncia | ||||
| Portugal | ||||
| Influence of the Composition on Fundamental Characteristics of a Water-Soluble Binder for MIM | ||||
| Helio Jorge, CTCV-Technology Centre for Ceramics and Glass Industry & Antonio M. Cunha, University of Minho, IPC-Institute of Polymers and Composites | ||||
| U.S.A. | ||||
| The Effect of Powder-Particle Size on the Debinding Rate Using Supercritical Fluids | ||||
| Rolf Schlake, Al Kaziunas, Applied Separations | ||||
| Spain | ||||
| Solar Sintering of M2 HSS | ||||
| Gemma Herranz, Gloria Rodriguez, Universidad Castilla La Mancha | ||||
| Thailand | ||||
| Effects of Sintering Temperature and Sintering Time on Mechanical and Impact Properties of Injection Moulded Ti-6Al-4V Employing Prealloyed and Mixed Powders | ||||
| Khuntong Songsiri, Anchalee Manonukul, Prasert Chalermkarnnon, National Metal and Materials Technology Center & Hideki Nakayama, Motoi Fujiwara, CASTEM (Thailand) Co., Ltd. | ||||
| Next | ||||